濟南鋁板http://m.aeih.cn/噴射清洗法的應用廣泛，由于設備復雜，工藝要求較高，清洗效果不佳，那么如何做好工業鋁型材噴射的清洗呢？

1、濟南鋁板噴射清洗需要加強工藝廣利，嚴格執行操作規程,每天檢查運行狀態，時刻觀察工藝參數,禁止工件停滯在設備中，以免生銹。
Jinan aluminum jet cleaning process needs to be strengthened Guangli, strict implementation of the rules, check the operation status of every day, always observe the process parameters, prohibit piece stuck in the device, to prevent

rust.

2、注意水洗質量。濟南鋁板為了減輕污染程度，首先應盡量減少工件夾帶清洗液污染下道工序。另外應考慮多級水洗，一般為二級水洗，有的工藝還是用純水洗。后一級水洗用水最大玷污不超過前一級清洗工件的十分之一，這樣二級洗工件的殘液濃度僅為原來濃度的，百分之一。在添加清水洗時，采用逆流補充，以節約用水。
Note water quality. Jinan aluminum in order to reduce pollution levels, the first piece should minimize entrainment cleaning fluid contamination under the procedure. It should also be considering multi-stage washing, usually two washing,

some process or with pure water. One of the largest pre-washed with water contamination does not exceed the level of the work is very clean after level, so the secondary wash only original piece of residue concentration concentration,

one percent. When you add water to wash, using countercurrent supplement to conserve water.

3、泡沫及其控制。濟南鋁板清洗劑的質量并不取決于泡沫的多少，而在往里噴射時，要求清洗劑是低泡的，否則批量生產就不能正常進行。
Foam and control. Jinan quality aluminum cleaning agent does not depend much foam, and in the inside injection, require cleaning agents are low foaming, otherwise mass production can not be normal.

4、除油劑的配方。由于單一組的清洗劑效果差，所以濟南鋁板http://m.aeih.cn/生產上一般采用多組分，復合型的清洗劑，因為由強堿，弱堿，聚合無機鹽，表面活性劑等適當配合而成的符合清洗劑，能有地發揮各自的洗凈特性，因而能顯著地提高洗凈效率。
Foam and control. Jinan quality aluminum cleaning agent does not depend much foam, and in the inside injection, require cleaning agents are low foaming, otherwise mass production can not be normal.